Skip to main content

Your Cart

Your cart is currently empty.
Click here to continue shopping.

Siemens Deka 60# Injectors - Set of 6

Fueling - Siemens Deka 60# Injectors - Set Of 6
Fueling - Siemens Deka 60# Injectors - Set Of 6
Fueling - Siemens Deka 60# Injectors - Set Of 6
Slim line flow matched and balanced 60 pound injectors are for high HP applications where an aftermarket power adder is being used. These are good for 600HP on gas. They are high impedence injectors so they are plug and play for your 3800 car. The slim design saves 276 grams total over 42# Lucas injectors! Injectors of this size require PCM programming on most applications.

This is a great injector for E85 conversions and will make up to 375WHP using E85.

2001+ NA cars require injector connectors or adaptors. L67 cars will chose EV1 connectors, and L32 cars will chose the EV6 connectors.
All ZZP purchased injectors come with dielectric grease and are packaged in a reusable plastic case to store your factory injectors safely.


  • Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
  • Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min
  • Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min
  • Gain: 0.11ms/mg
  • Offset: 0.055ms
  • Turn on time @ 14VDC: 1.14ms
  • Turn off time: 0.85ms @ 600KPa
  • Series: DEKA 4 ( DEKA IV )
  • Orifice Type: Multi-orifice
  • Spray Pattern: 30 Degree Spray Cone
  • Factory fitted with Viton upper and lower o-rings
Fueling - Siemens Deka 60# Injectors - Set Of 6
Fueling - Siemens Deka 60# Injectors - Set Of 6
Fueling - Siemens Deka 60# Injectors - Set Of 6
Customer Reviews
5.0 Based on 15 Reviews
Write a Review Ask a Question
  • Reviews
  • Questions

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
Martin O.
United States United States
Quality Product

Using them to run E85. I am currently in the middle of the install. Just got the PCM back. I will update once I get a few goes in with them. Again great customer support from ZZP in helping me switch over to E85.

Trysten H.
United States United States

Just need the injector connector

Jake S.
United States United States
Worked as advertised

Good injectors, 3800 in a fiero, on e85, 3.3 pulley, exhaust, intake... idc is 54%... can’t wait to go turbo and see how far these injectors will go.

Charles M.
United States United States
Great service

Overall great service. There was a delay with my order due to some other items not being in stock but the were great in keeping me updated and expediting the shipping once everything was in stock. As for these injectors, I installed them in an engine I am building for a Fiero kit project so I dont know how well they work yet but the plastic case with shadow cut foam was very nice. They dropped right in and connected to the factory plugs. So far I am very impressed.

60 lb Dekas

I would give them ten stars if possible. So easy to program in!