7

Angled O2 Bung

SKU: ZZ-AO2B

$29.99 Sale price

Model
Regular price $29.99

There are two versions: there is a thread in one that can thread into your factory o2 bung and be turned 180 degrees to clear the car, or there is a weld in version.
This will remove the o2 sensor from the direct exhaust flow path and reduce the chance of throwing a Check Engine Light for installing a high flow cat.
By running the rear o2 this will keep the car from running the catalyst test mode and reducing your highway MPGs.

You are viewing a product listed on the following platform:

3800
Ecotec
Sonic-Cruze

There are two versions: there is a thread in one that can thread into your factory o2 bung and be turned 180 degrees to clear the car, or there is a weld in version.
This will remove the o2 sensor from the direct exhaust flow path and reduce the chance of throwing a Check Engine Light for installing a high flow cat.
By running the rear o2 this will keep the car from running the catalyst test mode and reducing your highway MPGs.

Customer Reviews

4.9 Based on 7 Reviews
5 ★
86% 
6
4 ★
14% 
1
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review Ask a Question
  • Reviews
  • Questions

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

JA
10/29/2018
Justin A.

No Trouble Codes

Installled this along with the ZZP downpipe on my 2019 Sonic RS and haven’t thrown any trouble codes. It was a tight fit during the install but can be done without unbolting the rear of the resonator pipe.

PJ
12/20/2017
Patrick J.

**** Relocation

**** Relocation

AM
07/27/2017
Adrian M.

02bung

Nice weilds clearance is perfect

JM
07/02/2017
Justin M.

Works well

ZZP was out of their angled ****, so I bought this one. It seems to work fine, the only problem is if you use it with the ZZP downpipe, it hits the hangers prematurely. You can only screw it in about 3 or 4 turns. Just torque it down tight and it should be good to go. Overall it's a very nice product.

RK
04/06/2017
Robert K.

a very solid 90 degree ****

I bought this with the threaded connector (a bit extra $$). It was worth it. It's designed so the nut locks it down at any angle you need for the exhaust. The brass washer insures a good seal. I did not use any sealant at all, which is really good...I didn't want anything to outgas and damage the O2 sensor (even if it says "sensor safe").

Be the first to leave a review!

Write a Review

Author
Rating
1 2 3 4 5
Questions
Photos

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!